109387, Москва, ул. Люблинская, 42, офис 108 +7(495) 351-88-01 351-88-02 main@tiscom.ru
Cisco Catalyst Switch Module 3012 (43W4395)
Cisco Catalyst Switch Module 3012 (43W4395)
Производитель:
IBM
Идеальный коммутатор для шасси IBM BladeCenter S. Поддерживается также всеми остальными шасси. 14 внутренних портов 1Gb для подключения к серверам и 4 внешних порта 1Gb. Выполненный в виде USB консольный порт. Полностью неблокируемая внутренняя архитектура. Знаменитое качество Cisco по весьма разумной цене. Общие средства управления с внешними коммутаторами Cisco® — интерфейс командной строки IOS и решение CiscoWorks LAN Management Solution. Решение для тех , кто не привык экономить на качестве,но и не желает переплачивать за излишества.
| Наименование | Cisco Catalyst Switch Module 3012 (43W4395) |
| Порты подключения |
14 внутренних портов 1000T 4 внешних порта с автоопределением 10/100/1000T USB-RS232 консольный порт (кабель в комплекте) |
| Производительность |
36-Gbps switching fabric
Forwarding rate based on 64-byte packets; up to 36 million packets per second (mpps) |
| Поддержка MIB |
BRIDGE-MIB (RFC1493)
CISCO-CLUSTER-MIB |
| Поддерживаемые протоколы |
IEEE 802.1d Spanning Tree Protocol (STP) IEEE 802.1s Multiple STP (MSTP) IEEE 802.1w Rapid STP (RSTP) IEEE 802.1p Tagged Packets IEEE 802.1Q Tagged VLAN (frame tagging on all ports when VLANs are enabled) IEEE 802.1x port-based authentication IEEE 802.2 Logical Link Control IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3ab 1000BASE-T Gigabit Ethernet IEEE 802.3z 1000BASE-X Gigabit Ethernet IEEE 802.3ad Link Aggregation Control Protocol IEEE 802.3x Full-duplex Flow Control on all ports |
| Поддержка VLAN | До 1005 VLAN |
| Безопастность |
IEEE 802.1x allows dynamic, port-based security, providing server authentication. IEEE 802.1x with VLAN assignment allows dynamic VLAN assignment for a specific server, regardless of where the server is connected. IEEE 802.1x and port security are provided to authenticate the port and manage network access for all MAC addresses, including those of the server. IEEE 802.1x with an ACL assignment allows the use of specific identity-based security policies, regardless of where the server is connected. IEEE 802.1x with Guest VLAN allows servers without IEEE 802.1x clients limited network access on the guest VLAN. Cisco security VLAN ACLs (VACLs) on all VLANs prevent unauthorized data flows from being bridged within VLANs. Port-based ACLs (PACLs) allow security policies to be applied on individual switch ports. SSHv2, Kerberos, and SNMPv3 provide network security by encrypting administrator traffic during Telnet and SNMP sessions. SSH, Kerberos, and the cryptographic version of SNMPv3 require a special cryptographic software image because of U.S. export restrictions. Secure Sockets Layer (SSL) provides a secure means to use Web-based tools such as HTML-based device managers. Dynamic ARP Inspection (DAI) helps ensure user integrity by preventing malicious users from exploiting the insecure nature of the ARP protocol. DHCP Snooping prevents malicious users from spoofing a DHCP server and sending out bogus addresses. This feature is used by other primary security features to prevent a number of other attacks such as ARP poisoning. IP Source Guard prevents a malicious user from spoofing or taking over another user's IP address by creating a binding table between the client's IP and MAC address, port, and VLAN. Private VLANs restrict traffic between hosts in a common segment by segregating traffic at Layer 2, turning a broadcast segment into a nonbroadcast multi-access-like segment. Private VLAN Edge provides security and isolation between switch ports, helping ensure that users cannot snoop on other users' traffic. Bidirectional data support on the Switched Port Analyzer (SPAN) port allows Cisco Secure Intrusion Prevention System (IPS 4200 Series Sensors) to take action when an intruder is detected. TACACS+ and RADIUS authentication enables centralized control of the switch and restricts unauthorized users from altering the configuration. MAC address notification allows administrators to be notified of servers added to or removed from the network. Port security secures the access to an access or trunk port based on the MAC address. After a specific time period, the Aging feature removes the MAC address from the switch to allow another server to connect to the same port. Multilevel security on console access prevents unauthorized users from altering the switch configuration. The user-selectable address-learning mode simplifies configuration and enhances security. BPDU Guard shuts down Spanning Tree Protocol PortFast-enabled interfaces when BPDUs are received, to avoid accidental topology loops. Spanning Tree Root Guard (STRG) prevents edge devices not in the network administrator's control from becoming Spanning Tree Protocol root nodes. IGMP filtering provides multicast authentication by filtering out nonsubscribers and limits the number of concurrent multicast streams available per port. Dynamic VLAN assignment is supported through implementation of the VLAN Membership Policy Server (VMPS) client function to provide flexibility in assigning ports to VLANs. Dynamic VLAN enables the fast assignment of IP addresses. 1000 security access control entries are supported. |
| Энергопотребление | 12V at 3.75A (45W) (maximum) |
| Индикаторы |
Всего 10: -8 индикаторов активности -2 индикатора состояния модуля |
| Физические размеры | 112 X 30 X 260 mm |
| Вес | 1.1 кг |
| Параметры среды |
Operating temperature: 32° to 104° F (0 to 40°C)
Storage temperature: -13° to 158°F (-25 to 70°C) |
| MTBF | Примерно 436,000 часов |
Схема модуля Cisco Catalyst Switch 3012 :
1. Консольный порт USB
2. Переключатель режимов (кнопка)
3. Светодиодные индикаторы (Неисправность-левый, питание-Правый)
4. Порты 10/100/1000
Коммутатор Cisco Catalyst Switch 3012 и поддержка отсеков расширения BladeCenter:
| Description |
 Part Number |
|
|
|
|
|
|
|
|
|
|
|
Gigabit Ethernet integrated on the server planar |
None |
Y
|
Y
|
N
|
N
|
N
|
N
|
N
|
N
|
N
|
N
|
|
Ethernet Expansion Card (CFFv) |
39Y9310 |
Y
|
Y
|
Y
|
Y
|
N
|
N
|
N
|
N
|
N
|
N
|
|
Ethernet Expansion Card (CIOv) |
44W4475 |
N
|
N
|
Y
|
Y
|
N
|
N
|
N
|
N
|
N
|
N
|
|
QLogic Ethernet and 4 Gb FC Card (CFFh) |
39Y9306 |
N
|
N
|
N
|
N
|
N
|
N
|
Y
|
N
|
Y
|
N
|
|
2/4 Port Ethernet Expansion Card (CFFh) |
44W4479 |
N
|
Y
|
N
|
N
|
N
|
N
|
Y
|
Y
|
Y
|
Y
|
|
QLogic Ethernet and 8 Gb FC Card (CFFh) |
44X1940 |
N
|
N
|
N
|
N
|
N
|
N
|
Y
|
N
|
Y
|
N
|
Вариант установки с использованием внутренних портов лезвия:
| Diagram reference | Part number / machine type | Description | Quantity |
| 1 | Varies | IBM BladeCenter HS22 or other server | 1 to 14 |
| 2 | None | Ethernet controller on the system board of the server | 1 per server |
| 3 | Varies | Any BladeCenter server | 1 |
| 4 | 43W4395 | Cisco Catalyst Switch Module 3012 | 2 |
Вариант установки с использованием внутренних портов лезвия и карты CFFv или CIOv (4 порта на сервер) :
| Diagram reference | Part number / machine type | Description | Quantity |
| 1 | Varies | IBM BladeCenter HS22 or other supported server | 1 to 14 |
| 2 | None | Ethernet controller on the system board of the server | 1 per server |
| 3 | Varies | Compatible CFFv or CIOv expansion card | 1 per server |
| 4 | Varies | Any BladeCenter chassis | 1 |
| 5 | 43W4395 | Cisco Catalyst Switch Module 3012 routing signals from the CFFv or CIOv card (3) | 2 |
| 6 | 43W4395 | Cisco Catalyst Switch Module 3012 routing signals from the integrated controller (2) | 2 |
Вариант установки с использованием внутренних портов лезвия и карты CFFv или CIOv и карты расширения портов CFFh (8 портов на сервер) :
| Diagram reference | Part number / machine type | Description | Quantity |
| 1 | Varies | IBM BladeCenter HS22 or other supported server | 1 to 14 |
| 2 | None | Ethernet controller on the system board of the server | 1 per server |
| 3 | Varies | Compatible CFFv or CIOv expansion card | 1 per server |
| 4 | 44W4479 | 2/4 Port Ethernet Expansion Card (CFFh) | 1 per server |
| 5 | 8852 | BladeCenter H chassis | 1 |
| 6 | 43W4395 | Cisco Catalyst Switch Module 3012 routing signals from the integrated controller (2) | 2 |
| 7 | 43W4395 | Cisco Catalyst Switch Module 3012 routing signals from the CFFv or CIOv card (3) | 2 |
| 8 | 43W4395 | Cisco Catalyst Switch Module 3012 routing signals from the CFFh card (4) | 4 |
| 9 | 39Y9314 | Multi-switch Interconnect Module | 2 |
Информация для заказа:
Cisco Catalyst Switch Module 3012 for IBM BladeCenter 43W4395 (WS-CBS3012-IBM-I)
Введенная Вами информация будет передана нашему специалисту, отвечающему за данный вид продукции.
Вы получите квалифицированный ответ в ближайшее время.
Copyright © 2015 - Tiscom